Shenzhen HSJ Metal Fabrication Co., Ltd.
Shenzhen HSJ Metal Fabrication Co., Ltd.

6 Essential Inspection Methods to Master for Auto Stamping Parts

Touch Inspection of Auto Stamping Parts


Clean the surface of the outer cover with a clean gauze. The inspector should wear touch gloves and touch the surface of the stamped parts along the longitudinal direction of the car, and this inspection method depends on the experience of the inspector. When necessary, use oilstone to polish the detected suspicious area and verify it, but this method is still an effective quick inspection method.


Oil Coating Inspection of Auto Stamping Parts


Clean the surface of the outer cover with a clean gauze. Then use a clean brush to uniformly coat the entire outer surface of the stamped part with oil in the same direction. Place the oil-coated car stamped part under strong light to inspect it. It is recommended to place the car stamped part vertically in the position of the car body. With this method, it is easy to find small bumps, dents, and ripples on the stamping automotive parts.


Grinding of Flexible Wire Mesh on Auto Stamping Parts


Clean the surface of the outer cover with a clean gauze. Use flexible sandpaper to grind the entire surface along the vertical direction of the car stamped part. Any bumps or dents will be easily discovered.


Oilstone Grinding of Auto Stamping Parts


  • First, clean the surface of the outer cover with a clean gauze. Then use an oilstone (20×20×100mm or larger) to grind the parts with arcs and areas that are difficult to reach (e.g., semi-circular oilstones of 8×100mm) with relatively smaller oilstones.


  • The selection of oilstone granularity depends on the surface condition (such as roughness, galvanization, etc.). It is recommended to use fine-grained oilstones. The direction of oilstone grinding is basically along the longitudinal direction, and it fits well with the surface of the stamping automotive parts. In some special areas, horizontal grinding can also be supplemented.


Visual Inspection of Auto Stamping Parts


Visual inspection is mainly used to find the appearance anomalies and macro defects of stamping automotive parts.


Gauge Inspection of Auto Stamping Parts


Place the auto stamping parts in the gauge and conduct inspections according to the operating requirements in the gauge manual.


When we receive requests from customers, there will always be a reliable team to support and provide professional replies to customers, saving time for customers and advancing the project rapidly. For each feedback received, we will reply and provide effective results in a short period of time.


Establishing a long-term cooperative relationship with HSJ is a win-win situation for both our customers and our employees. Welcome to consult.

Related Products
Relate Blog
Resources Products
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Visit our cookie policy to learn more.
Reject Accept